1 / 3
Model No. : | DC-017AYZ1 DC Power Jack |
---|---|
Brand Name : | SJ |
Product description
| Mechanical characteristics | ||
| Item | Conditions | Specification |
1 | Insertion force | Measurement shall be made after insertion and withdrawal using standard plug gauge 3 times. | 2.9429.4N0.33kgf |
2 | Withdrawal force | Measurement shall be made after insertion and withdrawal using standard plug gauge 3 times. |
| Electrical characteristics | ||
| Item | Conditions | Specification |
1 | Rating | DC 12V,1A | |
2 | Contact resistance | 1K Hz Measured at small current (1A or less) | 30 mΩ or less |
3 | Insulation resistance | A voltage of 500V DC shall be applied for a minute. Between conductors which should not make contact under normal conditions after which measurement shall be made. | 100MΩ MIN. |
4 | Dielectric strength | Between conductors which should not make contact under normal conditions. 500V AC 50 to 60Hzfor 1 min.(trip current 2mA) | Without distinct damage. |
| Endurance characteristics | ||
| Item | Conditions | Specification |
1 |
Solderability | The terminals shall be dipped into soldering flux, and shall be immersed into molten solder of 230°C±5°C for a period 3±0.5 seconds. | A new uniform coating of solder shall cover a minimum of 75% of the surface being immersed. |
2 | Resistance to soldering heat | Solder temperature350±10 Immersion depth2±0.5mm Immersion time3±0.5 seconds By a soldering iron to have a capacity of 60 watts. | Electrical and mechanical characteristics shall be satisfied. |
3 | Cold | The jack shall be stored at a temperature of -40°C±2°C for 96 hours. And then it shall be subjected to the controlled recovery conditions for 0.5 hours after which measurement shall be made. | Electrical and mechanical characteristics shall be satisfied. There shall be not show remarkable failure. |
4 | Dry heat | The jack shall be stored at a temperature of 70°C±2°C for 96 hours. And then it shall be subjected to the controlled recovery conditions for 0.5 hours after which measurement shall be made. | |
5 | Humidity | The Pin Jack shall be subject to 90~95%RH, 40±2 for 96 hours, and shall then be conditioned at room ambient conditions for a period of 30 minutes. | Electrical and mechanical characteristics shall be satisfied. Insulation resistance30MΩ MIN. Contact resistance50mΩ MAX. |
6 | Life test | Insertion and withdrawal shall be made with the mating plugs and jacks for 5000 cycles at a speed of 10~30 cycles/min. |
Insertion force29.4N MAX3Kgf Withdrawal force1.9629.4N 0.23kgf
Contact resistance Between plug and contact100 mW MAX. Each closed contact60 mW MAX.
|
| Product Picture |
Product Dimension Drawing |
How to contact us ? |
Send your inquiry to this supplier