Specifications tyre recycling machine
1.safe cutting
2.competitive price
3.stable quality
4.long cutter service life
Tire strip cutter Process flows: waste tires--- circle cutting--- strip cutting--- block cutting--- magnetic separating--- finished product.
Rubber powder processing equipments The whole set of rubber powder making equipment consists of three main parts: scrap tires separating equipment, crusher set and grading magnetic separator. 1. Scrap tire separating equipment These machines are special for disintegration, circle cutting, strip cutting and chunk cutting of scrap wire tires. (1) The circle cutting machine is an alone accessory machine, where the tire is put flat on the machine and the tire is greater than 650 type (both nylon and steel wire) .locking tire inside opening through up and down locking system, then putting alloy tools to target to the place of disintegration of tire to cut off the mouth and nation of tire, finished in 3 minutes.
Name of product | Motor power | Weight | Designed yield | Specification |
tire circle cutting machine | 4 KW | 650 kg | 40pcs/h | 650- 1200 mm |
(2) Strip cutting machine make use of two round special cutting tools to combination running cutting. It can cut the tire of circle cutting into 3-8mm wide strip, to use for dicer cutting. The material of this machine’s knife disk is special alloy structural steel; diameter of knife disk isΦ390mm, hardness is 58-62GrS, more durable.
Motor power | Work range | Processing speed | Dimension | Weight |
4 KW | 650-1250 mm | 20-35 strips/h | 1300mm*800mm*1650mm | 850kg |
(3) Block cutting machine: the machine is prepared for the crush of host machine, Not only it makes the cutting strip-type waste rubber cut into about 3*8cm small pieces, but also can enter into host machine again through mutual use between sword and fixed knife, convenient to feed, high output and won’t damage roller easily.
Name of product | Motor power | Weight | Designed yield | Dicer specification |
block cutting machine | 5.5 KW | 800 kg | 0.8 T/h | 3*5*8 cm |
2. Crusher set The crusher set consists of rubber crushing mill, conveyor and main vibrating screen. The rubber crushing mill is a set of complete machine that mainly used for grinding and powder manufacturing. It’s equipped with alloy chilled cast iron rolls which are hard and wear-resisting. The temperature adjusting device could fill cooling water into the roller to adjust temperature to meet the technical requirement. The machine is easy-operating, reliable with overload protection and emergency breaks; it adopts hand wheel to adjust spacing between rollers. The hourly output of the machine is 100-400 kilograms.