SBS modified rubber plastic asphalt liquid coiled material

SBS modified rubber plastic asphalt liquid coiled material

Product overview

SBS modified rubber and plastic asphalt liquid coil (also known as SBS polymer modified rubber waterproof coating) is styrene monobutadiene monophenene (SBS) thermoplastic elastomer as a modifier, high quality petroleum asphalt is modified, and add a variety of rubber, synthetic resin, surfactant.Milk, chemical agent, mildew prevention agent and other auxiliary materials, by professional equipment refined and become a single component water-based high elastic waterproof coating.Excellent construction performance, smooth hand feel.Green environmental protection, brush facade slope does not flow, drying speed is fast, product construction drying time for half an hour to two hours.Good film elasticity, with super tensile resistance and bonding performance, elongation can reach ten times the thickness, automatic reduction, with good anti-blast performance.Open the bucket is brush, without mixing, convenient construction, has a good water resistance and long-term rain resistance, sunscreen and frost resistance, ultraviolet resistance, blister resistance, acid and alkali resistance, long life and other characteristics.

Product characteristics

1. Single-component cold construction does not require on-site deployment and is easy to use.

2. Water-based coating, low smell, no coal tar and other toxic substances, anti-combustion, is a green environmental protection products.

3. Excellent mechanical properties, high elasticity, super bonding, aging resistance and other characteristics, more suitable for the base structure easy cracking and deformation of the waterproof treatment, the correct construction has the effect of not peeling off the skin.

4. Have strong self-healing ability, can repair the pierced holes, waterproof quality is guaranteed.

5. Has a strong waterproof and anti-ultraviolet effect, -50-88C can be used, the life is up to 20 years, and can reduce the roof temperature, low temperature still has good elasticity, is the best choice of building roof waterproof engineering.

6. Easy to construct and convenient post-maintenance, low comprehensive cost, high cost performance, is the replacement of traditional coil products.

scope of application

1. Suitable for all kinds of concrete masonry structure building plane facade waterproof and moisture-proof treatment, also applicable to basement, wine kiln, air shelter, garage and other wall waterproof, moisture-proof treatment.

2. Especially suitable for roof, basement, garage, floor, kitchen and bathroom and other waterproof construction and key engineering Bridges.Tunnel, road and other engineering construction of waterproof, moisture-proof construction and treatment engineering.

Base surface processing

1. The base surface must be flat, solid and clean, free of oil, film agent, dust and other pine animals.

2. For larger holes and cracks should be repaired with deer water without leakage or plugging king.

3. Yin and Yang Angle should be first with deer water or plugging king into a circular arc (or V type).

4. Before using the Mongolian deer-003SBS modified rubber and plastic asphalt liquid coil, the base surface must be fully wet with clear water, but no water accumulation.

matters need attention

1. Base surface treatment, the foundation surface should be solid and clean, no oil pollution and sand, potholes, no open water and cracks, etc.

2. Fine treatment: Fill the sealing material (rapid plugging king) in the remaining groove according to the design requirements; the Yin and Yang Angle and tube root part shall be treated into circular arc or obtuse angle before construction, covered with grid cloth and painted in multiple channels.

3. Large face brush: first the base wetting saturated but no water, roll coating, spraying, two construction, interval to non-stick hand, and the brush direction into a cross, to prevent leakage brush.

4. Closed water test: After the film is completely dry and fixed (expected to be 3-5 days), the water outlet should be blocked for water storage. The water storage depth should be not less than 20mm, the water storage time should be 24 hours, and the water surface is not significantly reduced.