Preformed dead end tension Clamp

Preformed dead end tension Clamp
The Preformed Dead End Clamp can replace the traditional bolt-type strain clamp, wedge-type strain clamp, compression type strain clamp; its notable features: pre-twisted legs formed by the tubular structure of the natural winding in the wire, the clamp high strength , Reliable grip strength, clamp grip strength of not less than 95% CUTS (strands to calculate the breaking force); clamp stress evenly distributed on the wire, without damage to the wire, improve the anti-vibration ability of the wire.

Product introduction

The Optical cable preformed aerial strain clamp is used to connect terminal support, tension support, splice support and support of angle greater than 25^° .

The configuration of High Strength Preformed Dead End Tension Clamp includes terminal support-1set/support, tension support-2sets/support, support of angle over 25^° (angle) .

Users according to the fiber cable diameter, RTS or span selection suitable Tension clamp.

The preformed dead end guy grip for strain clamp includes: Inner preformed armor rods, outer tension preformed rods, a thimble clevis, a clevis, two anchor shackles.

Product structure

1. Inner preformed armor rods: Made of Aluminum-clad steel, with particulate grit applied to increase friction. The terminals bend toward outside to keep cable form abrasion.

2. Outer tension preformed rods: Made of Aluminum-clad steel, the individual rod assembled into groups to increase the strength of tension clamp in the condition of decreasing the stress imposed on cable.

3. Thimble: Hot galvanized steel.

There are five types of failure loads: 20KN.50KN.70KN.100KN.120KN.

4. Clevis: Hot galvanized steel. It used to connect to thimble clevis and anchor shackle. There are four types: 50KN.70KN.100KN.120KN.

5. Anchor shackle : Hot galvanized steel. Connecting support fastening.

The type: U-4 is 40KN, U-7 is 70KN, U-10 is 100KN, U-12 is 120KN.

our factory

Jiangsu Chuandu Electrical Technology Co.,ltd is specialized in Electric Power fitting for 18 years.The company was founded in 1999 with the registered capital reaching RMB 100 million, covers an area of 41000 ㎡.The company is a technology-based manufacturing-type enterprise which mainly produces and sells electrical fittings of various specifications and types for high and low voltage transmission and power stations.

Manufacturing Workshop