Manual Fire Alarm Call Point

Addressable Fire Alarm Control System Manual Call Point AW-AMC2188
Features and Technical parameters:
1. Executive standard: GB19880-2005
2. Operating voltage: 24V (pulse modulation)
3. Operating current: <300uA (in the monitoring status); <2mA (in the action status)
4. Output contact: Normally open contact; Capacity: 0.1A/30VDC
5. Weight: About 120g
6. Wiring method: Nonpolar two-bus system (L1, L2)
7. Operating environment: Indoor, temperature: -10° C~+50° C; Relative humidity: ≤ 95% (40° C± 2° C, without condensation)
8. Coding method: It can realize online coding with the help of a coder and without the necessity of disassembling the bus (however, the equipment must be powered off). Address codes 1 to 324 are available for selection.
9. Telephone jack: Two-wire fire telephone jack (equipped with a standard 6.3 single-track audio connector).
10. Starting part: A plastic pressing sheet that may be used repeatedly. It can be manually reset with a special tool after being pressed.
11. Starting mode: Press the pressing sheet manually.
12. Indicator: The red ALARM indicator will blink in the inspection status or remain lit in the alarm status; The PHONE indicator will blink when a fire telephone loop is connected, otherwise it will be out.
Matched host machine: Fire alarm control panel (such as AW-AFP2188)