High Speed Centrifugal Spray Dryer for Malt Syrup

LPG Spray Dryer for Malt Syrup:

Descriptions:

For the LPG series high speed centrifugal spray dryer, it consists of of liquid delivery system, air filtering and heating system, liquid atomizing system, drying chamber system, air exhausting and material collecting system, control system and  so on

Principle:
After been filtered and heated the air enters into the air distributor on the top of the dryer. The hot air enters into the drying room in the spiral form and uniformly. Passing through the high-speed centrifugal sprayer on the top of the tower, the material liquid will rotate and be sprayed into the extremely fine mist liquid beads. Trough the very short time of contacting the heat air, the materials can be dried into the final products. The final products will be discharged continuously from the bottom of the drying tower and from the cyclones. The waste gas will be discharged from blower.




 Spray Dryer Equipment Adaptable materials
 Chemical industry: Sodium fluoride (potassium), basic dye pigments, dye intermediates, compound fertilizers, formaldehyde silicic acid, catalysts, sulfuric acid agents, amino acids, white carbon, etc. 
 Plastic resin: AB, ABS emulsion, urea-formaldehyde resin, phenolic resin, adhesive (urea) formaldehyde resin, polyethylene, polyvinyl chloride and so on. 
 Food Industry: Fat-enriched milk powder, Taro, cocoa powder, milk replacer, blood powder, egg white (yellow), etc. 
 Food and plants: oats, chicken juice, coffee, instant tea, spices, protein, soybeans, peanut protein, hydrolysates, etc. 
 Sugars: Corn syrup, corn starch, glucose, pectin, maltose, potassium sorbate, etc. 
 Ceramics: Alumina, tile materials, magnesium oxide, talcum powder, etc.

Ordering Information
 ◎ material liquid name, physical properties: solid content (or water content), viscosity, surface tension, PH value. 
 ◎ Powder capacity after drying, allowable residual water content, particle size, maximum allowable temperature. 
 ◎ Production, daily opening hours. 
 ◎ Available energy: steam pressure available, capacity, available for coal, oil, gas. 
 ◎ Control requirements: whether the inlet and outlet temperatures need to be controlled. 
 ◎Powder collection requirements: Whether or not to install a bag trap, the environment requires exhaust emissions. 
 ◎ other special requirements.

 Technical specifications

Note: The amount of water evaporation is related to the characteristics of the material and the hot air inlet and outlet temperatures. When the outlet temperature is 90 o C, the water evaporation curve is shown in the above figure (for selection reference). As the product is continuously updated, the relevant parameters are changed without prior notice.

   Technical specifications