Heat Pipe Collector with Solar Keymark EN12975 (DIN CERTCO) and SRCC

Heat Pipe Solar Collector for Split Pressurized Solar Water Heating System

HS Code: 8419191000

Certificates: CCC, CE and Solar Keymark EN12975 (DIN CERTCO) and SRCC

Daily Production: 5000 PCS

Exports: Global

OEM: Available

 

• Working principle of Split Pressurized Solar Water Heating System:

1) When the discrepant of the heat pipe solar collector and pressurized water tank reaches the set value, the controller shall start the circulation pump automatically.

2) The circulation pump makes heat-conducing liquid circulate automatically.

3) The heat-conducting liquid transfers heat to water by heat exchanger in the pressurized water tank.

4) In case the temperature of the pressurized water tank dose not reach T max, then start the auxiliary heating device

5) If discrepant temperature of the heat pipe solar collector and the pressurized water tank does not reach the set value, the circulation pump shall be shut automatically.

6) There is no water in the vacuum tube. It can still work well with some tubes broken.

7) The liquid in the copper Heat pipe is anti-freezing. Don’t worry the systems be frozen in the cold winter.

8) Test Pressure is 600Kpa, and working pressure is 100Kpa. You can get hot water with high pressure which is very comfortable for shower.

9) The heat pipe solar collector can be installed far away from pressurized water tank.

10) The heat pipe solar collector can be installed on both flat roof and inclined roof.

 

• Structure of Heat Pipe Solar Collector
   

 

• Material Specification of Heat Pipe Solar Collector:

1, Header: Copper/ thickness 1.0mm

2, Outer casing: 2.0mm Anodized AL

3. Insulation: Rock wool and PUF

4, Frame: 1.2mm Stainless Steel or 2.0mm AL

5. Vacuum Tube: 3-targets, coating ALN/ALN-SS-CU, glass thickness 1.6mm, efficiency 0.94-0.96

6, Heat Pipe: copper/ thickness 0.6mm, surrounded by Aluminum fin to help heat transfer.

7, Certified by Solar Keymark EN12975(DIN CERTCO) and SRCC, please be rest assured about our quality.

 

Model Type	GDL-SP58-1800
Manifold casing material	Aluminum painted un-oxygen layer
Frame material	(Aluminum or Stainless Steel or Galvanized Steel) and painted Layer
Header pipe material	Copper
Heat pipe material	Copper
Insulation	Polyurethane 55mm or Glass-reinforced polyester
Rubber seals and rings	UV stabilized high temperature silicon rubber
Test pressure	6bar
Collector mounting	Plane roof/slope roof
Angle of operation	0~90 degree
Inlet Outlet	1/2 or 3/4 inch male

 

• Available Accessory for Split Pressurized Solar Water Heating System:

1, Controller
2, Electric Heater
3, Reflector(Aluminum or Stainless steel)
4, Silicon Sealing Rings
5, Assistant tank
6, PEX Pipe
7, Insulation Pipe
8, Brass Ball Valve
9, PA Connection
10, Thermostatic Valve
11, Magnesium Stick