Factory Direct Supply Semi-automatic Electric Ice Shaver

   Recommend Products     Factory Direct Supply Semi-automatic Electric Ice Shaver   Product Show    

Basic parameters of products
Name:	Electric Ice Shaver
Brands:	ETON
Model:	ET-200
Size:	390X240X340mm
Power:	220 V
Frequency	50Hz
Output:	200W
Out put:	0.12(t/h)
Packaging:	Carton
MOQ:	100

  Product Introduction   The ice machine surface through a special process, blade made of high quality stainless steel and refined, easy to wear. The machine also has a beautiful appearance, high crushed efficiency, simple operation, safe, durable advantages.   Procedure:
1, Before using, please read this manual to understand the structure and performance of the machine, familiar with the machine's main components and related security operations to better play its advantages, to achieve satisfactory results.
2, the machine should be installed in a sufficient supporting force table and the ground there is a proper distance.
3, before power, check the power supply voltage is used, and this machine is consistent with the voltage, outlet compliance with safety standards, and has been installed leakage protection switch and take a good ground. Confirm all meet the electricity requirements.
4, before the boot, the first to break the ice about 20 mm in diameter, can be placed into the barrel, the upper convex through the barrel mouth is appropriate. Note that the first opening of the power switch, to be the driving force of the motor to rotate the disc after the charge allowable dynamic binder cover plate pressed down on the handle, then fastened by rotating cutter blade on the ice chopped. But operating binder cover when pressed down on the handle can not be too much force, so as not to damage the motor turn the motor block. And should pay attention to the balance of the reduced ice feed replenish new ice slug.
5, ice chopped through the discharge port flows into the dish. Pay attention to the discharge port of the material smoothly, can not be blocked, otherwise it will cause stuck knives, burn out the motor. Cutter found to be stuck, you should immediately lift the binder cover handle, turn off the switch, unplug it, and remove the fault.
6, ice thickness is possible by adjusting the height of the protruding cutter blade opening to achieve, first remove the plastic disk protection when adjusting the switching device, loosen the screws fixing elbow, pull out the barrel, and then release Cutter fastening screw and remove the cutter, and then release the blade clamping screw, according to your requirements, in place, and then sequentially knife disk, etc. can be back in place.   Company Information   nack ma