Exterior Latex Paint of Top Grade

Intended Uses

Paint film has excellent resistance to weather, alkali water and pollution with adhension and wash resistance to substrate. It is of convinient construction, nontoxity and safety. Accordng to technical target requirements of national standard GB/T9756-2001,the product is of top grade. It can be applicable to cement mortar, concrete uralite, ceiling and other base material surfaces. It is mainly used as protection and decoration of external walls of industrial plants or civil architecture and other buildings.    

Product Description

The product is external latex paint prepared bysilicon acrylic emusion, excellent quality pigment and filler and multiple auxiliaries.

Product Information

Dry Film Thickness: 30microns
Theoretical Coverage: 139g/ (calculated by 36μm dry film)
Practical Coverage: Allow appropriate loss

Application Details

Method of Application:
Brush or Roller: Recommended, only for small area
Conventional Spray: Adoptable but thin to 5-10%, Tip range: 2-2.5mm
Thinner Deionized water or clean water, water-adding volume≤ 5% (weight)
Storage Life Six months
Drying Time(Substrate Temperature 25º C) Touch Dry ≤ 60min Hard Dry ≤ 2h Overcoating Interval: Minimum 2h Maximum No limit
Painting number 2 coats

Storage and Handlina

Storage: Store in cool and dry conditons
Pack Size 25kg
Specific Gravity: Approx1.50kg/L

Specification and Surface Preparation

For clean and dry wall which has been painted with high grade building latex paintspecial sealer or compound latex paint intermediate coating, the paint can be dierectly used. If the wall is polluted again paint it after removing pollution.

Subsequent Paint/Limitations

Preceding Paint: Use high grade building latex paintspecial sealer or compound textured latex paint intermediate coating
Limitations:
1. Paint shall be stored in shady, dry warehouses without direct sunlight at 0-40º C.
2. It is not proper to construct when temperature is lower than 10º C and relative humidity is higher than 85%.
3. It must be stirred evenly before painting. Strictly control diluent content.
4. Oil stain or organic solvent are strictly prohibited to be mixed into paint during use.
5. It shall use paint of the same batch number on the same building as much as possible.
6. Please do not conduct solvent-based coating application around, before the paint is dried so as to avoid yellowing and floating of solvent coat.
7. It can be handled as non-dangerous articles in transport.