Continuous waste plastic pyrolysis plant

Continuous waste plastic pyrolysis plant

There is no doubt that continuous waste plastic pyrolysis plant is based on batch equipment design, so their main pyrolysis process is consistent with the principle, the latter is only more intelligent and easier to operate, which also reduces the more manpower and material resources. Its main advantage over small pyrolysis equipment is that it can continue to work 24 hours a day. There is no need to stop in the middle because of loading and unloading or cooling, which can save a lot of time and make the whole process more efficient.

First of all: Put the collected plastic products into the plastic crusher and crush the waste plastic. This will not only save space but also accelerate the reaction speed of waste plastics in the furnace, and in short, it can improve the operating efficiency of the equipment.

Secondly, the broken waste plastic is fed into the reactor through a pusher and the reactor is heated. The temperature of the reactor reached a certain height, and waste plastic pieces cracked out of oil and gas, carbon black.

Once again, the oil and gas that has been cracked enter the condensing system. When the hot oil and gas meets cold, it is liquefied into heavy oil and falls into the oil tank.

Then: For the treatment of the three wastes of waste gas and waste water generated during the operation of the equipment, the company launched a desulfurization and deodorization tower system to thoroughly help customers solve the problem of factory odors and meet European and American environmental protection and emission standards.

Finally, the carbon black be outputed.

Continuous waste plastic pyrolysis plant advantages

Advantages of continuous waste plastic pyrolysis plant:

1. The PLC control system can improve equipment operating efficiency.Because it can  continuously feed materials continuously for 24 hours. Great savings in manpower and material resources.

2. The single machine processing capacity is large and the floor space is small, saving the cost of purchasing land in the previous period.

3. Use an accurate calculation system to ensure that the feed is fully cracked and the oil yield is high.

4. Indirect heating system, long service life.

The end products of DoingGroup's continuous waste plastic cracking equipment mainly include fuel oil, carbon black and combustible gas. Their specific uses are as follows:

Fuel oil usage

1. Fuel oil: Mainly used for heating oil in iron and steel plants, and boiler plants. It is also commonly used in heavy oil generators to generate electricity.

Carbon black usage

2. Carbon black: Carbon black briqutting can be produced for burning, refining from carbon black , can be produced  for new tires, and pigment manufacturing materials.