6*4 SINOTRUK 600m deep truck mounted borehole drilling rig machine

SINOTRUK Truck-mounted drill is for drilling water well This model is suitable for oil field, it can work in -40°C—+40°C and can meet demand of working operation, the design is advanced, reasonable and conformity with HSE standard, also it can extramely decrease the operator’s intensity of labor by it’s reliability, good maintainability, Simple operation, operational reliability..   1.      SPECIFICATION OF WHOLE TRUCK: Max. Loading Capacity: 900kN Rated Loading Capacity: 600kN Depth of the workover ig (minor repairs): 4000m(2-1/2 oil pipe)         (major repair):3200m(2-7/8 drill rod) Loading way: Vehicle loading Fuel Type: Diesel SPECIFICATION OF MAIN COMPONENTS    CHASSIS PART:    Molde of Engine: Dongfeng Commins ISEL 375    Power of Engine: 261kW/r/min    HYDRAULIC GEARBOX    Model: BY352    Max. Input Power: 294kW/2200r/min    Max. Input torque: 532N.m    torque conversion Ratio: 2.4:1   TRAVELLING SYSTEM: 6X4 HYDRAULIC SYSTEM: it’s composed of oil box, gear oil pump, overflow valve, hydraulic jack and so on. The Hydraulic System is divided into chassis hydraulic operating part(including whole truck hydraulic steering part) and workover rig hydraulic controling parts(including whole truck reguation, workover rig stand in, stretch out and draw back, hhydraulic tong return circuits and others) AIR CIRCUIT SYSTEM Air Circuit operating system is working by Air compressor operation by Engine, it's mainly composed of air compressor, air reservoir, air source processor, air valve, air circuit pepes, it supplys compressing air for operatiing device and chassis. WINCH Winch is applied with workover rig winch, expansion cylinder is with LeBus grooving, ropes in order, big output power, braking form is applied with band brake, it's chain and sprocket drive beween right angle gear box and winch. Model of Gearbox: ATD-224-H push clutch. Max. quick rope pull: 120kN Diameter of steel rope: 7/8″(22mm) OIL DERRICK Form: front opened two-section drilling masts, it's supported by rear bracket connections. Materials: 16mn rectangular steel tubes, steel plates, channel steel, angle steel. Lifting modes: hydraulic telescopic Max. Working load: 900kn operational height: 22m Operational angle: 5.5° wind resistance capability: 100km/h(10 grade)   FRONT AND REAR BRACKET Front and rear brackets are fixed on the transport vehicle, when it moves, front and rear brackets support the oil derrick, rear bracket swivel joints with oil derrick by pin roll, the pin roll is as the center for rotating oil derrick and rising on the rear bracket when operating.   HYDRAULIC WINCH Model: iyj3b(3 tons) Diameter of expansion cylinder * length:216×299mm Cope capacity: 100m(3/8″steel rope) maximum scale tension:30kn   2. OTHER NOTICE INFORMATION the manufacture standard is applied with SY/T5610-1995 petroleum workover rig form. whole vehicle components are applied with API SPEC 4F,8C,7K standard. Installation of crown-block protector, electronic weight indicator.