Product description
Description
-
No-load Speed:10000 rpm
-
Air Consumption:8CFM
-
Air inlet Size:1/4 Inch
-
Working Pressure:6 - 8 kgf/cm²
-
Product Name: Pneumatic Sander Machine
-
Model: AT-980V-5
-
Material: Aluminium Alloy + Plastic
-
Sanding Pad Diameter: 125mm
-
Applicable Sandpaper: 5 inch
-
Uses: Car polishing glaze waxing
-
Feature:
- The best hand stress on the tool is from 5kg to 7kg when operation.
- Artificial design, small and excellent polishing and polishing tools, the operation is not easy to fatigue
- small volume,high speed, low noise.
- High balance, the use of time does not produce fatigue ,high stability.
- Light weight, high degree of bottom, easy to handle, can be operated with one hand;.
- Different types of sandpaper can be installed by replacing different polishing discs.
- Small size and easy to carry, the metal material is durable.
- Vacuuming pneumatic sander for 5-inch and 6-inch pallets Cost-effective, reliable mass.
-
Note:
- Release the air supply when replacing the sand paper or the backing pad.
- Wear protection glassess,eye protector,dust mask and gloves at operation.
- Have a short break in every 30 minutes to avoid any possible injure due to tiredness.
- Do not touch the rotating part of the tool with your hand or your body at operation.
- Do not have free rotating at high speed to avoid possible injure to human body and possible tool damage.
- Start your sanding job after you fit the sanding pad flat on the surface you are working on.
- Stop your job when finding any irreguar sound or vibration at operation and then check and repair the tool.
- Because that you are using clean compressed air at operation.Use an air filter at the air installation to clean the dust out of the compressed air.
- Drop some oil to the motor and then run the tool and then run the tool slowly for a minute and finally start your work auto lubricator/oiler is recommended.
- Any dirt dust inside the motor may result in slow rotation even block running,at this time,try to drop some oil from inlet,see whether slove the problem.
- Do release the water out of the air compressor and air hose after operation.
- Maintain tools with care.Keep tools clean for better and safe performance,follow instructions for lubricating.Inspect tools cords and air hoses periodically,if damaged,have them repaired by an authorized technician.
Package include
-
1 x 5 Inch Air Sander Machine
-
1 x Small Hex Wrench
-
1 x Bayonet Quick Connector
-
1 x 1m Air Tube
-
1 x Cloth Bag
-
1 x Instruction Manual