2mil VLT 72% Chameleon Window Film

  2mil VLT 72% Car Window Tinting Film TECKWRAP Car Window Film

Product:	Car Window Tint
Product code:	KSB88
Size/roll:	1.52(width)x30(length)m
Weight:	10kg
Materials:	High-performance PET
Thickness:	2mil
Visible light Transmittance:	65%
IR Transmittance:	45%
Ultraviolet Transmittance:	1.2%
Stand up against:	Water, dirt, grease, salt, weak acids oil
Heat resistant:	-30 to 300 degree

   Features:   1. Eco-friendly materials   2. Easy to apply. Very flexible wrap vinyl when heat is applied.   3. Easily to remove. Without residue.     4. Water resistant, can be easily cleaned by soap and water   5. High heat rate              In the hot summer, it can prevent infrared and ultraviolet damage to the body, and save air- conditioning energy as well.   6. To prevent fading          It can protect goods and decorating inside cars from fading.   7. Safety explosion-proof   It can effectively prevent the flying glass fragments, ensure belongings and personal safety.   8. Anti-dazzle                     It can decrease the solar heat, effective in reducing glare, especially in the glare mirror.   9. Anti-scratch                   Scrub resistance and durable.   10. Enhanced Privacy   Window tint helps protect your privacy within a car. And make it more attractive.   11. Decrease Interior Heat   Your car’s interior can be up to 60% cooler by using a quality window tint, creating a more comfortable ride.   12. Protect Your Skin   Harmful UV rays from the sun can contribute to skin cancer. Tinting your car can block most of these damaging rays.   Tools For Wrapping: Snap-Off Blade Knife, Straightedge, Triangle hard scraper, Soft Squeegee, Sprayer  1. Film Cutting. Cut Paper Pattern on outside glass. Trim film to fit that paper pattern. 2. Make soapy water solution Mix 5-10 drops detergent with 500g water in Sprayer. Well-proportioned them by shake the sprayer up and down. 3. Clean window Spray soapy water on glass and scraping the glass by soft squeegee. From top to bottom or left to right. Do it again by 2-3 times. (Make sure the glass is clean) 4. Separate film from liner. Peel film apart from backing. Spraying water on adhesive while peeling just to prevent films sticking together. 5. Place film on glass. Spray some soapy water on adhesive and glass. Then place film on glass to the exact place. (More soapy water, easier to move film during installation). 6. Scrapping Spray soapy water solution on film surface and squeegee firmly to wipe out all the water. The liner can be put on the film during scrapping to prevent film from scratching. It should be scrapped from middle to both sides. Lightly scrap at first, squeegee firmly after the film is fixed on the glass. The scrapping will be finished once all water wiped out. 7. Trim film with new sharp blade, leaving 1/16” gap around edges 8. Drying time 3 days in full sun