10/100M Standlone Managed Fiber Media Converter

10/100M Standlone Managed Fiber Media Converter

With the same bus bandwidth, the power consumption of the serial interface is also smaller than that of the parallel port. And the working mode of the equipment is changed from parallel transmission to serial transmission, and the speed of the serial can be doubled with the increase of frequency. N-net NT-LM105,Fast Media Converter with low consumption and high resistance to electromagnetic interference of the optical fiber make the transmitting distance spread from 100m to several decades KM or hundred KM, improve the communication quality as well. Based on FPGA has the advantages of embedded Gb rate level and low power consumption architecture, it can enable designers to use high-efficiency EDA tools to quickly solve the problem of protocol and rate changes. And make the server, repeaters, switch, terminal PC connect easily.Fiber To Ethernet Converter is specially designed for remote monitoring and managing those fiber transceiver modules, power modules  situation of fiber-optic link, which work in the rack, based on a widely used standard---SNMP. Easy provide users with stable fiber-optic IP network solutions.

Fiber To Ethernet Media Converter Feature

1.Support LFP function.

2.Support Q-in-Q function, Optical port and Ethernet port can be set separately as dual Tag ports, and can be set as ISP Tag and ISP Tag TPID at will.

3.Can query and configurate the operation mode of each port on local and remote devices, including port speed, full/half-duplex, and flow control, etc, and can display the real-time status of each port.

4.Support bandwidth-limiting function:with the step of 64kps, the bandwidth can be set between 0Mbps and 100Mbps at will.

5.Offer MIB library files, support OpenView.Snmpc, and other softwares.

6.Support link line-speed loopback, convenient for line debugging

10/100M Media Converter  Basic Parameter 

Fast Media Converter Optical Port Connection

NT-LM105 supports hot plug SFP port. When one pair of optical modules is connected, four requirements need to be fulfilled.

1. Optical wavelengths must be the same, especially for single fiber optical ports, require transmit-receive optical wave with difference frequencies.  The transmitting and receiving operating wavelengths should match each other(for example: if TX is 1310nm, and the opposite end RX should be 1310nm).

2. The rate of optical modules must be the same.

3. The optical powers must be matching

4. Comply with the Ethernet protocol of IEEE802.3.IEEE802.3u.IEEE802.3z.IEEE802.3x.

Fiber To Ethernet Converter Network-buiding method

When connecting products in Network, Rules of 3.1 must be obeyed

Rules for connecting optical ports: for NT-LM105 fiber media converters, please build network according to the following

Sketch maps.

(1) 

(2)