TPV KD-155AN
KD-155AN is made in using the dynamic vulcanization high-tech high-performance EPDM/PP thermoplastic elastomer.It has good environmental resistance,low compression deformation performance;It can use the way such as extrusion,injection molding,blow molding processing molding,do not need to conventional vulcanization process of rubber processing;It is easy dyeing,make product design more flexible;It can be recycling reuse,more in line with environment protection requirements.
The typical performance in the following table:
| Physical Properties | Test Standard | Typical Value | Unit | |
| Hardness | GB/T531 | ISO 7619 | 55 | Shore A |
| Density | GB/T533 | ISO 2781 | 0.97 | g/cm3 |
| Tensile Strength | GB/T528 | ISO 37 | 4.9 | MPa |
| Elongation at Break | GB/T528 | ISO 37 | 460 | % |
| Tear Strength | GB/T529 | ISO 34 | 15 | kN/m |
| Melting Index | GB/T3682 | ISO 1133 | 3.8 | g/10min |
Attention:Did not indicate the test temperature above is 23℃
The typical molding process in the following table:
| Injection Molding Conditions | Extrusion Molding Conditions | ||||
| TemperatureSetting | Front endMesomerePosteriorJet | 180-215℃180-215℃180-215℃187-220℃ | TemperatureSetting | Front endFillter SectionMeasuring SectionPosterior | 180-200℃180-205℃187-210℃187-210℃ |
| Shrinking Percentage | 2.1%~3.1% | Expansion Rate | 0%-15% | ||
Attention:Molding material should be dry(80℃×2Hour)
