Hydraulic trolley lift platform

Small electric hoist can overhang operations, across some obstacles or can carry out multi-point operations at a lifting; platform loading capacity is large, for two or more people working at the same time , can carry a certain equipment; lifting platform mobility, transfer convenience; appearance, suitable for indoor and outdoor work and storage.

1 before the operation, the air barrier and high voltage should be checked, and according to the current regulations and standards, the platform should be kept safe distance from the charging line. Must be on a solid and flat ground to work, must make the platform on the load and distribution in line with the provisions of the production plant. Should be used in accordance with the use of the production plant to use a leg or stabilizer, the platform should be properly fastened to the safety belt.
2 in the work process, the platform staff should always have a stable foothold.
3 in the course of operation, there should be no fault or the mistake in the operation should be immediately ruled out, and we can continue to use.
4 prohibition of making, modifying or discarding safety devices.
5 in the platform to rise, fall or move, should pay attention to preventing wire rope, wire, hose, etc..
Two.1. lift platform, the operator shall not be less than three.
2 power supply connected to the mainframe platform, installed guardrail, carefully check the effect of the existence of hidden field operation.
3 pull the support legs, the rotary supporting rotary rod, and make the ground support. Adjust the leg level, but it is not suitable to make the four wheels all out of the ground.
4 push up the handle of the oil cylinder, so that the pressing oil cylinder slowly rising, the release of the push rod in the vertical position. Note: lift cylinder in place after the release of the operating handle, and the closure of the lift cylinder motor, a long time to give the cylinder pressure will seriously affect the hydraulic valve and the life of a variety of cylinders.
5 observe the level of the instrument, fine tune the leg level. Note: iron level instrument may have artificial damage or offset, should be in the level adjustment at the same time, the observation of the verticality of the telescopic oil cylinder, found problem is to check the level of the instrument, did not rule out the problem before the ban lifting of the lifting platform.
6. A telescopic oil cylinder base about the two M12 screw holes, used for fixing the telescopic oil cylinder, remember: before the lifting platform must be fixed screw, use to the lifting platform movement and inclination, to loosen the fixing screw.
7 oil cylinder after the vertical release of anti rotation ladder clamping screws, the top of the ladder to prevent the transfer of a screw.
8 put the switch in the manual position, check the manual button. Put the switch in the remote control position, check the remote control.
9 operators on the lifting platform, check the fence screw is connected to the firm, fasten the safety belt.
10 start the remote control button, or have ground personnel operation.
11. Platform to highly, press the stop button, the platform stop rising, holding to the required position, press the down button, falling platform, delay switch for 10 seconds after the accelerated decline, such as to adjust the rate of decline for an extended period of time, open electric control box can be adjusted.