1 / 3
Model No. : | CAT30,CAT40,CAT50 |
---|---|
Brand Name : | QFMH |
place of origin : | China |
Jining, Shandong, China
Product description
CAT Standard Face Mill Holder Tool Holder ,The
whole through hole is beneficial to water outlet and has good seismic
resistance. The plane milling shank is mainly used for clamping the
shank and cutter in drilling, milling, reaming, tapping and grinding.
The surface milling cutter handle is made of titanium alloy du20crmnti, which is wear-resistant and durable. The tool handle hardness is 58-60 degrees, low noise, low wind resistance and high precision of repeated clamping. It is a special tool holder for face milling cutter head.
CAT Face Milling Holder The cutter bar requirements are as follows:
To be clamped tighter, better rigidity, small deflection accuracy of machining
tool, in this case, can the effectiveness of potential play!
CAT Face Milling Holder The cutter bar check the accuracy of the matters
needing attention:
1, the accuracy of the accuracy and reliability of the scale, the unit of
measurement of at least 0.002mm.
2, the main test bar according to international standard
3, the accuracy of the tungsten steel mold qualified. Control shaft diameter
tolerance within H6.
4, the cutter bar in the front, thoroughly clean all parts, such as the collet
nut etc.. And at the same time, should pay attention to the cleanliness of the
machine spindle.
5, the cutter bar clamping tungsten steel mold bar, the need to comply with all
kinds of tool rod device description of. In order to avoid clamping precision
caused by improper, distortion.
6, if the measurement. 180 degree deviation, the reason may be the bolt head or
mechanical spindle taper precision etc..
CAT Face Milling Holder
Jining, Shandong, China
Send your inquiry to this supplier