304 stainless steel cleaning machine

304 stainless steel cleaning machine

1.304 stainless steel cleaning machine Refer to the installation manual of the Ultrasonic cleaning machine to connect the temperature control sensor signal line,ultrasonic drive line,heater control line between the control cabinet of the cleaning machine and the host,and connect the 380VAC power supply,install the water pipe of the cleaning machine,and put Water pipes and overflow discharge pipes.
2.Ultrasonic cleaning pool water
Add the appropriate amount of clean water to the cleaning tank.The height of the liquid surface shall be based on the parts to be cleaned by immersion.Generally,it does not exceed three quarters of the cleaning tank.
3.Ultrasonic cleaning and heating
Start the electrically controlled heating switch and point the white graduation mark on the water temperature adjustment knob to the appropriate temperature(it should be around 60°C).The maximum temperature of the cleaning agent should not exceed 70°C during use of the cleaning machine.
4.Ultrasonic cleaner added cleaning agent
When the water temperature rises to about 40°C,the UC-O3 component cleaning agent is added to the cleaning tank(usually about 5kg at a time),and the water is slowly stirred to fully dissolve(At this time,the more acoustic waves may be started or the gas blowing device may be started. Stir).
5.Ultrasonic cleaning machine pretreatment
Before cleaning,you should use a bamboo knife to clean the dirt on the surface of the parts first(for example,there will be a lot of dust on the outer surface of the dust cover,and the parts of the cylinder block will accumulate a lot of thick and easily removed sludge at the change of the housing curve).In order to extend the life of cleaning fluid.
Ultrasonic can perform precise cleaning,but its ability to treat mud-like dirt is weak.Therefore,in the pretreatment,yellow mud or slime-like dirt should be removed as much as possible.