Pig tail cable RG316 SMA to N male

                      RG316 pig tail cable with N female to SMA male               

  A pigtail connector is a unique connector type that can be handy during repair and maintenance projects. But cannot be used as a standalone project.It is a special RF Coaxial Connector with a connector on one end and lose wires on the other one. With like this SMA male and Female Connector ,or IPEX (MHF )Connector , you can attach two or more electrical conductors with an electric box

HOW DOES IT WORK?RG174 Cables

Step 1: Take a scrap wire and use strippers to cut ¾ inch of insulation from each end of the wire,LRM200 RF Coaxial cables

Step 2: Loop one end of this wire around the screw terminal of the device. Make sure to wind in the clockwise direction. Needle-nose pliers can prove helpful in this regard. Make sure the entire bare wire is looped without leaving any part of it exposed.LMR400 RF Coaxial Cable

Step 3: Connect the other bare end of the wire with the circuit wires. Even at this end, loop the bare wire fully. Suppose you attach a green grounding pigtail to an electrical box. In that case, the green grounding screw attached to the pigtail must be connected to the screw opening at the back of the electric box to complete the circuit. Attach the free end of the pigtail with the ground wires using the wire connector.

Step 4: Tug the wires to check if they are properly connectedRG58 RF Coaxial Cables

Step 5: For an electric fixture, you can tuck all the wires back in, put it inside the wall and cover it with the main plate, and you are done.LMR240 Coaxial cables