1 / 1
Options:
Model No. : | THD_ET15D5-S2 |
---|---|
place of origin : | China |
Zibo, Shandong, China
Product description
Product introduction: |
Application: |
Ø Power supply: ± 12V ~ ± 15V DC Ø Fluxgate principle - DC leakage current sensor; Ø The primary and secondary of the current sensor are insulated and can measure weak DC signals; |
Ø Signal system Ø Current difference detection Ø current detection of elevator Ø Leakage detection of DC screen |
Electrical characteristics:
Parameter |
Symbol |
THD10ET 15D5-S2 |
THD20ET 15D5-S2 |
THD30ET 15D5-S2 |
THD40ET 15D5-S2 |
THD50ET 15D5-S2 |
THD100ET 15D5-S2 |
|
Rated current |
IPN(A) |
10 |
20 |
30 |
40 |
50 |
100 |
|
Measuring range |
IP(A) |
0~±14 |
0~±28 |
0~±42 |
0~±56 |
0~±70 |
0~±140 |
|
Output voltage |
VO(V) |
±5.0*(IP/IPN),DC |
||||||
Load resistance |
RL(kΩ) |
>10 |
||||||
Working power supply |
VC(V) |
±12V~±15V DC±5% |
||||||
Insulation voltage |
VD(V) |
50/60Hz,1min,3kV;RMS |
General parameters:
Project |
Condition |
Date |
Unit |
Accuracy XG |
@ IPN,T=25℃ |
<±1.0 |
% |
Zero offset voltage VOE |
@ IP=0,T=25℃ |
<±50 |
mV |
Current offset temperature drift VOT |
@ IP=0,-40~+85℃ |
<±3.0 |
mV/℃ |
Hysteresis offset voltage VOH |
@ IP=0,after 1*IPN |
<±25 |
mV |
Linearity εr |
|
≤1.0 |
%FS |
Response time tra |
@ 90% of IPN |
<300 |
ms |
Operating bandwidth BW |
-3dB |
DC-20 |
kHZ |
Working temperature TA |
|
-10~+70 |
℃ |
Storage temperature TS |
|
-25~+70 |
℃ |
Static power consumption IC |
|
9.0+Is |
mA |
Product weight m |
|
65 |
g |
Shell material |
PBT material containing 30% glass fiber,Flame retardant grade:UL94- V0; |
||
Standard |
IEC60950-1:2001 EN50178:1998 SJ20790-2000 |
Structural drawing: (mm)
Connection diagram:
Remarks:
1. When the measured current passes through the primary pin of the sensor, there is a corresponding voltage signal output at the output end;(Note: wrong wiring may damage the sensor)
2. Products with different rated current can be designed according to the requirements of customers, and the output voltage of the sensor can be selected;
3. When the busbar is fully filled with holes, the dynamic performance is the best;
4. The temperature of primary conductor shall not exceed 100℃;
Zibo, Shandong, China
Send your inquiry to this supplier