Product description
Model NO.: 805-c
Shape: Square
Size: Middle-Sized
Power: AC200/110/50Hz
Trademark: joinstars
Transport Package: Carton Box
Specification: 50*60*50cm
Origin: China
Specification Weight: 30-31KGOverall Dimensions: 390mm×350mm×235mm Power: 160-300W Mode of Display: LCD Liquid Crystal Display Screen Cutting Length: 1mm - 9999mm Cutting Tolerance: ≤0.002×L (L = Cutting Length) Stripping Length: Head 0 - 35mm ,Tail 0- 15mm Cutting Cross-sectional Area of Wire Core:(508C 0.2-2.5 mm2 508-SD 0.1- 4.5mm2 )(508E 0.1-8 mm2 508-JE 0.1- 10mm2 )Maximum Diameter of Conduit Pipe: ¢11Middle-stripping: 10 places of stripping Material of Knife: High-quality Tungsten Steel
Stripping Speed: |
3000 - 80000 p c s /h |
Mode of Driving: |
Mode C Two-wheeled Drive |
Mode SD/SDB/E/JE Four-wheeled Drive |
Adjusting Speed: |
0 Slowest, 9 Fastest |
- Operating Principle
The wire is conveyed through the wire-inlet rollers and the wire-outlet rollers and the wire cutting and stripping is finished through the knife rack assembly, which are all controlled by microcomputer technology. - Introduction to Main Function of Every Part
1. Wire-inlet Rollers: for conveying wires and stripping wire heads. 2. Wire-outlet Rollers: for conveying wires and stripping wire tails.3. Knife Rack Assembly: for wire cutting, head stripping and tail stripping. 4. Wire-inlet Gap Adjusting Rollers: for adjusting the wire-inlet gap, turn it down to decrease the gap and turn it up to increase the gap. 5. Wire-outlet Gap Adjusting Rollers: for adjusting the wire-outlet gap, turn it up to increase the gap and turn it down to decrease the gap. 6. Conduit Pipe Assembly: for ensuring the wire smooth and straight and preventing the wire from moving defectively when the wire moves from the wire-inlet rollers to the knife rack assembly. - Key Points for Operation of Mechanical Parts
1. The wire is put into the wire inlet, through the wire-inlet rollers and the conduit pipe, and then onto the knife edge. 2. Wire-inlet Gap Adjusting: adjust the gap between the two rollers through the wire-inlet gap adjusting rollers to make the gap less than the outer diameter of the wire to be stripped so as to ensure normal stripping of wire covering. 3. Wire-outlet Gap Adjusting: adjust the gap between the two rollers through the wire-outlet gap adjusting rollers to make the gap less than the outer diameter of the wire to be stripped, and adjust the indicator light of wire breakage at the critical state between on and out, then turn up for half circle. If the machine still stops because the wire knobs, adjust the gap a little smaller.