2KW APS Pure Sine Wave Inverter with Charger and Voltage Regulator

APS Pure Sine Wave Inverter, Charger, Automatic Voltage Regulator

APS charger is a combination of APC inverter and automatic voltage regulator. While bypassing the input AC to power the loads, the APS pure sine wave inverter also stabilizes the input AC voltage within the range of 230V±10%. Connected with batteries, the APS inverter will run as a UPS with max. transfer time of 10ms
.
Features of APS Pure Sine Wave Inverter, Charger, Automatic Voltage Regulator
1. High overload ability of our APS charger is up to 300% rated power(20 sec.), and low voltage trip 9.5V/10V or 10V/10.5V is selectable.
2. APS pure sine wave inverter adopts low quiescent current, and power saver mode to reduce power consumption to 10W(3s sensing cycle)/3W(30s sensing cycle) *. It can extract max. power from various batteries with different protections.
3. The automatic voltage regulator supplies wide stabilizing AC range, and bucking/boosting voltage in 10ms.
4. Our APS pure sine wave inverter can offer 3-step intelligent battery charging, and equipped with 8 preset battery type selector for totally flat batteries. Its powerful charge rate up to 90Amp**. In addition, PFC(power factor correction) is adopted for charger, which has less power consumption than conventional units
5. 10ms typical transfer time between battery and AC, which guarantees power continuity of APS pure sine wave inverter. Its input AC voltage is selectable (184-253V or 154-253V) for different kinds of loads.
6. The APS charger has 15s delay before transfer when AC resumes, and the function of overload protection when it equips with generator. Also, it allows start up and through power with depleted batteries.
7. USB communication port, LCD status display, battery/AC priority switch are available for our APS pure sine wave inverter, it also has 17 alarms/warnings for easier operation and trouble-shooting, and ability to switch the unit on/off. In addition, select/deselect power saver mode can be used too.
Note:*For 1KW one. **For some models.

Technical Parameters of APS Pure Sine Wave Inverter, Charger, Automatic Voltage Regulator

Electrical Specvifications
	Model	APS1000W	APS1500W	APS2000W	APS3000W	APS4000W	APS5000W	APS6000W
Inverter Output	Continuous Output Power	1000W	1500W	2000W	3000W	4000W	5000W	6000W
Surge Rating(20s)	3000W	4500W	6000W	9000W	12000W	15000W	18000W
Output Waveform	Pure Sine wave/Same as input(Bypass mode)
Nominal Efficiency	>88%(Peak)
Line Mode Efficiency	>95%
Power Factor	0.9-1.0
Nominal Output Voltage rms	100-110-120Vac / 220-230-240Vac
Output Voltage Regulation	±10% RMS
Output Frequency	50Hz ± 0.3Hz/60Hz ± 0.3Hz
Short Circuit Protection	Yes( 10s after fault )
Typical transfer Time	10ms(Max)
THD	< 10%
DC Input	Nominal Input Voltage	12.0Vdc
( *2 for 24Vdc, *4 for 48Vdc)
Minimum Start Voltage	10.0Vdc
Low Battery Alarm	10.5Vdc / 11.0Vdc
Low Battery Trip	10.0Vdc / 10.5Vdc
High Voltage Alarm	16.0Vdc
Low Battery voltage recover	15.5Vdc
Idle Consumption-Search Mode	< 25 W when Power Saver On
Charger	Output Voltage	Depends on battery type
Charger Breaker Rating	10A	15A	20A	20A	20A	30A	30A
Max Charge Rate	35A / 70A
BatteryInitial Voltage for Start Up	10-15.7V for 12V( *2 for 24V, *4 for 48V)
Over Charge Protection Shutdown	15.7V for 12V (*2 for 24V, *4 for 48V)
Charger curve(4 stage constant current) 4 step digital controlled progressive charge	Batterytypes ( *2 for 24Vdc, *4 for 48Vdc)
Remote Control	Yes. Optional
Bypass & Protection	Input Voltage Waveform	Sine wave (Grid or Generator)
Nominal Voltage	110Vac	120Vac	220Vac	230Vac	240Vac
Max Input AC Voltage	150VAC	270VAC
Nominal Input Frequency	50Hz or 60Hz (Auto detect)
Low Freq Trip	47±0.3Hz for 50Hz, 57±0.3Hz for 60Hz
High Freq Trip	55±0.3Hz for 50Hz, 65±0.3Hz for 60Hz
Overload protection(SMPS load)	Circuit breaker
Output Short circuit protection	Circuit breaker
Bypass breaker rating	10A	15A	20A	30A	30A	40A	40A
Transfer switch rating	30amp for UL & TUV	40amp for UL
Bypass without battery connected	Yes
Max bypass current	30amp	40amp
Bypass over load current	35amp: Alarm	45amp: Alarm
AVR Function	Input AC Voltage Range	90-140V±4%	154-253V±4%
Stabilized Output Voltage rms	120VAC±10% rms	230VAC±10% rms
Nominal Voltage	110Vac	120Vac	220Vac	230Vac	240Vac
(A) Line Low loss N/W (On Battery)	84/72	92/78	168/143	176/150	183/156
(B) Line Low comeback N/W (On Boost)	89/77	97/83	178/153	186/160	193/166
(C) Line 2nd boost threshold (On Boost)	**	**	**	**	**
(D) Line 2nd boost comeback (On Boost)	**	**	**	**	**
(E) Line 1st boost threshold (On Boost)	99	108	198	207	216
(F) Line 1st boost comeback (On Normal)	103	112	205	215	225
(G) Line buck comeback (On Normal)	118	128	235	246	256
(H) Line buck threshold (On Buck)	121	132	242	253	264
(I) Line high comeback (On Buck)	127	139	253	266	278
(J) Line high loss (On Battery)	132	144	263	276	288
Mechanical Specifications	Mounting	Wall mount
Inverter Dimensions(L*W*H)	382*218*179mm	442*218*179mm	598*218*179mm
Inverter Weight	18KG	18KG	20KG	24KG	35KG	45KG	45KG
Shipping Dimensions(L*W*H)	520*315*300mm	580*315*300mm	740*315*300mm
Shipping Weight	20KG	20KG	22KG	26KG	37KG	47KG	47KG
Display	Status LEDs / Status LEDs+LCD
Standard Warranty	1 Year