Radar level flowmeter suitable for liquid, paste, granule and block material level measurement

Specifications Radar level flowmeter suitable for liquid, paste, granule and block material level measurement

1.Low dielectric constant

Radar level flowmeter suitable for liquid, paste, granule and block material level measurement            

Application	Low dielectric constant of the liquid
Measuring Range	6meters
Process Connection	Thread, Flange
Medium Temperature	-40°C ~ 250°C
Process Pressure	-0.1~4.0 MPa
Accuracy	± 3mm
Shell	Aluminum
Frequency Range	500MHz-1.8GHz
Signal Output	4... 20mA/HART (Two-wire / Four)
color	customized

                        l Principle   Radar level transmitter antenna microwave pulse is narrow, the downward transmission antenna. Microwave exposure to the medium surface is reflected back again by the antenna system receives, sends the signal to the electronic circuit automatically converted into level signals (because the microwave propagation speed, electromagnetic wave to reach the target and the reflected back to the receiver this time is almostinstantaneous).   A  Range set   B    Low adjustment   C   High   D   Blind area     Datum measurement:  Screw thread bottom or the sealing surface of the flange. Note:Make sure the radar level meter the highest level cannot enter the measuring blind area (Figure D shown below).               The Installation Requirements   l Installation guide:   Be installed in the diameter of the 1/4 or 1/6.   Note:The minimum distance from the tank wall should be 200mm.   Note: 1datum 2The container center or axis of symmetry       l The top conical tank level, can be installed at the top of the tank is intermediate, can guarantee the measurement to the conical bottom.   l A feed antenna to the vertical alignment surface.  If the surface is rough, stack angle must be used to adjust the angle of cardan flange of the antenna to the alignment surface.   (Due to the solid surface tilt will cause the echo attenuation, even Loss of signal.)