Protocol Converter with PPP

Specifications Access WAN port Router

Lowest cost access router solution

Compatible with CISCO, JUNIPER, HUAWEI

20 years OEM for DLINK CTC

      HT 350EL  Access WAN port Router CISCO Compatible WAN Router    Product Description      HT-350EL is HWATEL access wan router, access intelligent converter for low cost data access. Equiped With NEWest Freescale® PowerPC® RISC Network processor, provider much better performance than normal ARM based Router.       It can be use as the far end of CISCO®, JUNIPER®, HUAWEI®, HP, 3COM, Erricson, Nortel core router. Together with these core routers.It can construct a low cost, high performance, plug and play data communication network. OEM to DLINK®, CTC and many China Taiwan Companies.          Till now EL-350 is LOWEST cost product for WAN port Access Router. It is an low cost replacement  solution of CISCO 1900,2900, HUAWEI AR ,HP/3COM MSR.       Features  10/100Base-TX Ethernet to V.35 bridge/Router Perform LAN to V.35 protocol conversion Compatible to Cisco/Juniper router V.35 interface Support Synchronous HDLC (ISO 13239), PPP, CISCO HDLC Support Bridge Virtual interface[BVI], IP/HDLC or IP/cHDLC Auto MDI/MDIX Selectable data port : V.35, X.21, RS530, RS449,RS232 Transparent half / Full duplex support on WAN,LAN interface Nx64, Nx56 timing clock generator for Sync WAN link LEDs indication for LAN, WAN status Specification  WAN Interface Interface : Selectable RS232(Sync), V.35, RS530/449, X.21 (cable solution) Protocol : Synchronous HDLC (ISO 13239), PPP, CISCO HDLC Connector : DB25M Type : DTE port Data rate: RS232 up to 128Kbps ; V35, X21, RS530, RS449 up to 2Mbps; Nx64(56)Kbps up to 2048Kbps Clock source : Tx/Rx internal or external All Configuration by Dip switch (Protocol, interface, Clock mode, data rate)
LAN Interface Interface:   10/100 Base-T,IEEE 802.3 MAC Address filtering bridge  Compliant with IEEE 802.3, 802.3u
Connector: RJ45
Speeds: 10/100Base-TX, Full/Half duplex
Frames: Support 64 ~ 1536 byte packet lengths  Connector: RJ45  Bridge Router protocol Bridge Protocol: Synchronous HDLC (ISO 13239), PPP, CISCO HDLC
Bridge: IEEE 802.1D transport, self-learning
Router: IP/HDLC, Protocol Independent
Multicast[PIM] – V.35 to LAN direction
Multicast packet forwarding
Address learning, aging and deletion after 5 minutes
256 addresses MAC table
340 packet buffer IP Protocol  Bridge/Router Mode
IP Network Address Translation (NAT)
Access Authentication (PAP/CHAP) with PPP
IP/TCP/UDP/ARP/ICMP supported
HTTP/TFTP/Telnet support
RIP1/RIP2 supported  Management  Remote configuration with TELNET Multi Menu driven 
Embedded Web Based/HTTP Management
GUI based management  Environment Temperature: 0 ~ 60 degree C
Humidity: Up to 95% non-condensing CE marking EN 55022 and 55024 compliant
Safety: EN60950 compliant
Surge immunity: L1:L2 1KV, L1/L2:PE 2KV
Lighting Surge : 4KV  Power supply DC: 12 VDC AC: 90 ~ 260V AC (47 ~ 63 Hz)