Pressure 15psi - 75psi Shower / Kitchen Electric Water Purifier With Lcd Panel Screen

 

Pressure 15psi - 75psi Shower / Kitchen Electric Water Purifier with LCD Panel Screen

 

PRODUCT INTRODUCTION & PRINCIPLE

ECO Mini Purifier is an environmentally friendly appliance applied in bathing, kitchen washing, pet sterilizing and so on. With the efficiency of sterilizing, disinfecting and purifying water, ECO Mini Purifier is aiming at reducing the damage resulted from the bacteria which may be spread through water.

ECO Mini Purifier adopts advanced nanotechnology and permanent magnetic material to soft the tap water, through mixing the water in the static mixer for the first time, and then mixed with controllable ozone and silver ions, through the second time in the static mixer to make sure appropriate gas-liquid mixing proportion.

ECO Mini Purifier contains no water storage, meaning to purify and use water simultaneous, to avoid the second pollution due to storage

ECO Mini Purifier has the main functions as below:

 

Sterilization and disinfection;
Decontamination and purification;
Clean and softening;
Energy conservation and environmental protection
Smart & Low consumption

 

TECHNICAL SPECIFICATION TABLE

 

Model	ECO Mini Purifier (OLK-P-01)
Electrical	Input:AC120V∕60Hz Output:DC 12V 2.5A 30W
Ozone Concentration	0.3~0.5 mg/ L
Water Pressure	Minimum:15psi Maximum:75psi
Operate Temperature	0℃~78℃
Product Dimension	367mmX277mmX89mm
Net Weight	1.90 Kgs

 

USE & SAFETY CONSIDERATION

 

Before using, please read the User’s Manual carefully.
Do not operate the unit with the cover removed.
Disconnect ALL power before servicing.
Do not mount the ECO Mini Purifier vertically or at an angle.
Do not use an extension cord or a different power adapter (other than the one provided with your ECO Mini Purifier with this appliance).
Maximum water inlet pressure is 75psi.
Use the included new hose when connecting ECO Mini Purifier to the water tap.
Under residential use, the Silver Ion Probe installed in your ECO Mini Purifier has a life expectancy of approximately one and a half years. The red Service indictor lamp, seen through the window in the front of your unit will be lighted when the Silver Ion Probe requires replacement. The indicator lamp will glow blue when the unit is operating properly and will turn red when the probe requires replacement.
Use a soft cloth dampened with water. Do not clean your ECO Mini Purifier with harsh chemicals, abrasives or cleansers.
ECO Mini Purifier is designed for residential use only and is not intended for use in a commercial or industrial setting.
ECO Mini Purifier can work normally in the temperature category 0℃~78℃, without components breakdown.

 

STRUCTURE DIAGRAM

 

 

CONTROL PANEL DIAGRAM

 

	Part Name	Normal State	Abnormal State
	UV Light	Blue	Red
	Silver Ion Probe	Blue	Red
	Ozone	Blue	Red
	Water Leakage	Gray	Red

 

 

 

 

 

 

 

Red Light indicates one part works abnormally.

 

INSTALLATION INSTRUCTION

 

1. ECO Mini Purifier will offer a metallic plate, a power adapter, 4-1/4 tapping screws, a hose, a wrench, and a screwdriver as accessories.
2. The ECO Mini Purifier should be fastened to the wall, left above your tap. Firstly, fix the metallic plate on the wall. The metallic plate has three mounting holes, together with 3 anchor screws. Fasten the metallic plate on the wall with the anchor screws to support the product.
3. Before installation, do not open the unit. There are 3 sockets on the bottom of the unit.Collimate the 3 sockets in the holes of the metallic plate, pull downward slowly, and then the unit is hanging over the metallic plate.
4. Ensure that metallic plate is horizontal. Tilt installation may affect the product operation and visualization.
5. Connect the water inlet on the ECO Mini Purifier to the water supply faucet; and connect the water with the supplied hose. Make sure rubber washers are properly installed in both ends of the hose before connection. Properly tighten the hose to the inlet fitting, but do not over tighten.
6. Plug the supplied power adaptor into the DC adaptor plug-in on the side of the ECO Mini Purifier unit and then plug the adapter into the wall outlet. Disconnect the power adapter when not use the unit.

 

System Set Up

1.Turn on the water valve/faucet. Check the connections to ensure that there is no leakage or dripping. Tighten the hose connections, if necessary, but DO NOT over tight.

 

2.Connect power adapter, and then start your washer. Once the water begins to flow, the blue light of the ECO Mini Purifier should begin to glow.

 

Indicators

 

There are two states of the LCD control panel screen.

Blue Light: work normally.

Red Light: work abnormally or break down.

If the unit works abnormally, please contact our Customer Service.

 

Alarm of Leakage

 

ECO Mini Purifier is equipped with a switch and an alarm against leakage. If the leakage happens, the water will accumulate on the bottom panel inside the unit. The sensor will set off an audible alarm and will automatically turn the unit off. This alarm will continue to buzz until the leak is stopped and/or the unit is unplugged. If this alarm should occur, you should unplug the unit, turn off the cold water valve and call our Customer Service team for support.

 

Replacement of Silver Ion Probe

Under normal usage, the Silver Ion Probe installed in your ECO Mini Purifier has a life expectancy of approximately one and ahalf years. Theon the control panel will turn RED when the Silver Ion Probe requires replacement. Please contact our Customer Service team to order a new Silver Ion Probe and replace it as the following step:

 

1. Disconnect the power and take off the hoses connected to the water inlet and water outlet.
2. Turn off the water supply valve / faucet.
3. Turn on the wash machine momentarily to relieve any internal water pressure within the ECO Mini Purifier unit.
4. Turn off the washing machine and unplug the power adapter of the ECO Mini Purifier.
5. Push the ECO Mini Purifier a little higher than the metallic plate, and take it off from the metallic plate.
6. Find the 4 screws holes on the base, unscrew and press the cover, you will see the Silver Ion Probe ( see the structure diagram)
7. Unscrew the Silver Ion Probe with the supplied wrench, and then fix the new one. (Tighten the Silver Ion Probe in order to avoid water leakage.
8. Reconnect the electrical connectors of the new Silver Ion Probe, making sure that the retainer features snap together properly.

 

MAINTENANCE SERVICE

 

Your ECO Mini Purifier is warranted to be free from all defects in material and workmanship in normal household use for a period of (1) year from date of purchase.

The warranty is granted only to the original purchaser and members of his or her immediate household. The warranty is subject to the following provisions. Any damages or malfunctions caused by negligence, abuse, or use not in accordance with the Owner’s Manual are not covered by this warranty. Likewise, any defects or damages caused by unauthorized service or the use of other than Genuine Wowtech parts are not covered.

Wowtech will, at its option, repair or replace a defective ECO Mini Purifier or part(s) for the ECO Mini Purifier that is covered by this warranty. As a matter of warranty policy, Wowtech will not refund the customer’s purchase price. Please recorder the following Warranty Card when you purchase the unit from Wowtech or the distributor.

To obtain warranty service you must return the defective ECO Mini Purifier or ECO Mini Purifier parts along with proof of purchase to Wowtech or Wowtech Authorized Warranty Station. All transportation charges on parts, or units, submitted under this Warranty shall be borne by purchaser. Unless this Warranty is expressly renewed or extended by Wowtech, any repaired or replaced part of unit shall be warranted to the original purchaser only for the length of the unexpired portion of the original warranty.

Please contact us without hesitation if you need help.