PE and PP waterproof membrane for shower rooms

Product Information

PE and PP waterproof membrane for shower rooms

PP+PE+PP Compound building waterproof membrane is made by multiple-ply different materials, especially its aging 
and weathering resistance layer enables the membrane possess more longer effective age. It can bond with many kinds of adhesions, firm and secure. In case of cement-base, cementations agent can be used, the cementations agent can easily enter into the non-woven felt layer, forms a well-combination with cement after solidification, permanent durability.

Specification

PE and PP waterproof membrane for shower rooms

Thickness: 0.6mm,0.7mm,0.8mm,1.0mm,1.2mm,1.5mm

Weight: 200gsm,250gsm,300gsm,400gsm, 500gsm,800gsm.

Color: green,black, white etc

Width: 1M or customized

Length: 50M,80M,100M,or customized

Datasheet

1. Non-toxic, no pollution, environmental protecting product.
2. Can be used for many different surfaces, especially for cement basement.
3. Tough, impermeable, multi-layered sheet; 
4. High tension strength, good cold flexibility.

Uses

PE and PP waterproof membrane for shower rooms

1. The application is simple and no pollution. It is mainly used in the middle of building for waterproofing. On this layers of protection and decoration are needed; 

2. When application, pour the adhesive materials homogeneously on the smooth roof 
deck, then roll the membrane to make is fully adhered to the deck. 
3. The adhesive materials are usually made form cement or other building glue.
Products used in roofing, basement, restroom, water conservation, warehouse to protect structure from water infiltration.

Construction procedures

PE and PP waterproof membrane for shower rooms

Check leveling layer→Clean-up basic level →Preparation the cement binder→Do additional layer→Base construction→protective layer→Curing

Construction Method

1)The basic level must be clean, keeping moist.
2)Preparing cement paste, containing cement weighing 10% -15% polyvinyl binder,Mixing must be homogeneous,No precipitation,No clot,No segregation phenomenon can be used.
3)Before the construction of the main roof waterproof layer,firstly, the drainage and the places of complex structure should be dealled with well.  The waterproof membrane on the the additional layer is the same as the main waterproof layer.

4)The seal material can use poly ether type polyurethane, if use other sealing materials , they should be free of mineral oil, petrolatum and other chemical substances affecting the performance of polyethylene products.
5)Corner should be paved by the additional layer; yin and yang angle, etc. are made of R = 20mm arc-shaped.
6)Waterproofing membrane should be paved, adhesive should be homogeneous on the basic level surface, after that immediately pave the waterproof membrane , in case of affecting the bond quality.
7)Paving the waterproofing membrane shall not wrinkle, not forcibly stretch the membrane, the air  and the excess adhesive below the membrane should be dealled with well while paving the membrane, ensure the membrane spliced well with the primary surface and between the layers of membrane.
8)The lap width of the waterproofing membrane shall be not less than 100mm.
9)Upper-and-lower level and the adjacent membrane should be staggered to one-third of magnitude.

PE and PP waterproof membrane for shower rooms

Packing Details  : Packing  with woven bag and put in pallet(customized)
Delivery Details : 3-10 days after received the prepayment

Certification