linear rail system ATH5

Compared with the SMC embedded module: the channel and the base are attached, the inner channel of the module slide and the base are matched by the card slot, and the channel can freely extend and move, because the channel and the base are not tightly attached, affecting the operation. Precision. The DTH channel and the base of the company use glue developed by a special module slide to ensure that the base and the channel are closely fitted. Guarantee the running accuracy of the module. Channel hardness and module slide process, SMC channel has not been refined and ground, but the shape is extruded, the channel shape accuracy is not guaranteed, and the channel hardness is less than HRC58-62 degrees, the module will run for a long time. A gap has occurred. The company's channel is made by one-time grinding of precision grinding machine. The channel shape accuracy is controlled within 0.005mm. The hardness of the module slide is at HRC58-62 degrees. The characteristics of the module slide table ensure the long-term operation accuracy of the module. The moving seat and channel material TOYO moving seat and channel material are only carbon steel. In-line groove design: Modules of the same width can be increased by 30% compared to modules with rails. Optimized design: Since the groove is embedded and then shaped and ground, the height and parallelism of the walking are improved, which is 40% higher than that of the mounting rail form module. There is no need to install purchased rails and the cost is reduced.