led car door logo laser projector lightled car

Specifications 1. Wireless

2. High clear logo

3. No signal error

4. Best heat dispatch system

5. High clear film

Specification:   1. 5W Real CREE Chip
2. High clear film
3. 12-24V
4. Good material and super workmanship
 
Advantages:   1. Wireless
2. No need to drill hole, stick on the car directly
3. No signal error
4. Best heat dispatch system
5. High clear logo performance
6. Waterproof    
 
Install Instruction:
 
1.Install instruction about the batteries. Put 3pieces AAA (1.5V) batteries in the battery case and install them according the positive & negative that marked in the case.Then close the batteries case jacket.
2.Install instruction of the shadow light. Stick the Magnet on the bottom of the car frame. Stick the Car light on the car door. The distance between the Magnet & Car light is about 10mm. When close the car door, the Magnet is at the underface of the sensor in the car logo light.
3.Automatic Control & Manual Control.
When you open the door, the logo will be shown on the ground, and it will be off automatically after lighting on 2minutes. If you want to off the light, just need to press the button on the head of the light.When the light is off with the car door open, you can also press the button to control the light on. And the light will be also off automatically after lighting on 2 mins.
4.Some cars can not stick the Magnet on the car frame as there is no space for it. So it can only use Manual Control.