led aquarium lighting lamp uk with intelligent control

led aquarium lighting lamp uk with intelligent control

Match code :

1. Connect the lights with socket , turn off  power.

2. Press the“SET”button when power is on , the light has 50% brightness, it means code state.

3. Continuously press the "100% " Brightness button " three times ( the middle knob )  ,then 25% brightness and 10% brightness seperately and the lights will flash two times, then it is code successfully.  4. If it does not work then repeat the above steps ( 5 seconds to complete )  

Clear code :

1. connect lights with power ,turn off the power.

2. Press the“SET”button when power is on ,and the light has 50% brightness, it means it is in the code state.

3.Continuously press"DIY"three times, then25% brightness and 10%brightness , the light flash twice, then it  clears  code successfully.

4. If  it does not work, please repeat above step( 5 seconds to complete )

A.If many lights plug in the same socket , the code and clear can be done at the same time.   

B.The remote can control many lights in the scope .

C.2.4G remote, controlling can reach 50 meters.  

Remarks:  

1. After clear, the driver is “open mode”, the controller can control any of the lights.

2. After coding , the driver is “off mode”, only the related controller with code  can control the lights.

3.If you mix the lights, clear all of them, and code them one by one.

4. DIY: Adjust the lighting spectrum you want,and press"DIY"in 3 seconds until the flash , it is saved.