GP Series Water Pump (Self-Priming Peripheral Pump GP-125)

GP125 Series Self-priming Peripheral Pumps

GP self-sucking pump consists of clean electric pump, un-directional valve and saparation chamber of water vapour which are installed on the top side of pump body. During using, you shall not use the bottom valve, but only retain some water on the pump body and run it for a short time and through the function by pump itself, the water will be drawed up.

FEATURES

1. Models: GP-125
2. Stator: 100% pure wire coil( copper or aluminum as you require)
3. Rotor: Enough sillicone steel sheet with high durability
4. Shaft: Rust resistance with 45# steel or stainles steel
5. Compact size and Simple operation
6. Heavy duty continuous work.
7. High-efficient and Low noise


CONSTRUCT

Pump

Pump body: Cast Iron
Impeller: Brass
Mechanical seal: Carbon/ceramic/Stainless Steel

Motor

Single Phase
Motor Housing: Aluminum (closed, externally ventilated)
Shaft: Carbon Steel/ Stainless steel Thermal protector (if required)
Insulation class: B and F
Protection class: IP44 or IP54
Power: 220-240V 50Hz( single phase 230V, 240V, 127V, 110, 115V/60Hz are available)

OPERATING CONDITION

Liquid temperature up to 60
Ambient temper up to 40
Total suction lift to 9m
Continuous duty

TECHNICAL DATA(220-240V/50Hz)