Cyanuric acid drying equipment

Cyanuric acid drying equipment:
Easy installation and small occupying area. 
1. As the dryer is in a whole for delivery, it is quite easy to install and fix at site only by hoisting. 
2. As drying plates being arranged by layers and installed vertically, it takes a small occupying area though drying area is large. 

Cyanuric acid dryer:
Drying, heat decomposition, combustion, cooling, reaction, and sublimation 
1. Organic chemicals 
2. Mineral chemicals 
3. Pharmaceutical and foodstuff 
4. Feed and fertilizer 

Cyanuric acid drying equipment production line:
1.Drying plate 
(1). Designing pressure: general is 0.4MPa, Max. can reach 1.6 Mpa. 
(2).Work pressure: general is less then 0.4Mpa, and Max. can reach 1.6 Mpa. 
(3).Heating medium: steam, hot water, oil. When the drying plates` temperature is 100℃, hot water can be used; when 100℃~150℃, it will be saturated water steam ≤0.4Mpa or steam-gas, and when 150℃~320℃, it will be oil.
2.Material transmission system
(1).headstock revoluton:1~10 rpm, electromagnetism of transducer timing. 
(2).harrow arm: There are 2 to 8 pieces arm that be fixed on the headstock on the every layers. 
(3). Harrow`s blade: Surrounding the harrow`s blade, float together with the surface of the plate to keep contact. There`re various of types. 
(4). Roller: for the products easily agglomerate, or with the requirements of grinding, the heat transfer and drying process might be reinforced by placing roller(s) at the appropriate place(s). 
3. Shell There`re three types for option: normal pressure, sealed and vacuum 
(1). Normal pressure: 
(2). Sealed: Cylindrical shell, could bear the interior pressure of 5KPa, the main ducts of the inlet and outlet of heating media might be inside of the shell or outside. 
(3). Vacuum: Cylindrical shell, could bear the exterior pressure of 0.1MPa. The main ducts of inlet and outlet is inside of the shell. 
4. Air heater: 
Normal for the application of big evaporation capacity to increase drying efficiency. 

Jakarta Cyanuric Acid Drying Equipment Production Line:
     Wet materials are fed continuously to the first dryinglayer on the top of the dryer. They will be turned and stirred by rakes when the rake arm rotates and drop down to  the outer edge of the large drying plate along the exponential helical line. On the small drying plate they will be moved to its outer edge and drop down to the outer edge of the large drying plate underneath, and will be moved inward and drop down from its central hole to the small drying plate on the next layer. Both small and large drying plates are arranged alternately so as materials can go through the whole dryer continuously. The heating media, Which could be informs of saturated steam, hot water or heat conducting oil will be led into hollow drying plates from one end to the other end of the dryer. The dried materials will drop from the last layer of the drying plate to the bottom layer of the shell body, and will be moved by rakes to the dischargeport. The moisture escapes from materials and will be removed trom the moist discharge port on the top cover, or sucked out by the vacuum pump on the top cover for vacuum-type plate dryer. The dried materials discharged from the bottom layer can be packed directly. The drying capability can be  raised up if equipped with supplementary devices such as  finned heater, condenser for solvent retrieval, bag dust remover, return and mix mechanism for dried materials and drawing  fan etc. Solvent in those dried paste and heat sensitive materials can be easily retrieved, and thermal decomosition and reaction can be also carried out.

Remarks:Some of the parameters are for reference only.When design they will change according.