Specifications Cut-to-length lines, takes flat hot rolled steel or cold rolled steel, unrolls it, levels and cuts it to desired length
Hot Rolled /Cold Rolled cut-to-length line Our customers expect the sheets produced on the hot strip cut-to-length line to exhibit excellent flatness and minimal stress. The automated processes employed by our clients necessitate total consistency in terms of geometry, flatness and stacking condition. Our plants fulfil these requirements. The most important areas of application include mechanical engineering, special vehicle construction and stockholder supplies. cut-to-length line Layout
01.) Coil preparation 02.) Pay-off reel 03.) Pre-leveller 04.) Edge trimmer | 05.) Trimming scrap shear 06.) Leveller 07.) Cross-cut sheer |
| |
Strip width range | 900 - 2.000 mm |
Strip thickness range | 1,5 - 16,0 mm |
Coil weight | max. 32 t |
Sheet length | min. 1.000 mm / max. 16.000 mm |
Line speed | 60 m/min |
Common Applications: Blank-cuttting from coil materials in various sizes Avoiding high external service costs for blanks with inefficient lot sizes Reducing stock-keeping and purchasing costs by concentrating onto select coil sizes Increasing flexibility with just-in-time orders Typical Conventional Configuration: Pay-off - or pull-off reel with coil car Straightener with threading system with coil loop with loop control after exiting; with optional loop bridge Roll-feed with servo controller Cut-to-length shear Stacking system
Shear
Uncoiler
Leveler
Stacker