China Coal Type Extruder

1. Specification of the China Coal Type Extruder

Coal Type Extruder molding requirements: Due to the molding machine for material particle size, moisture content of materials, binder ratio and material have the certain requirement, and mixed material must also have good plasticity, which requires molding process of crushing, screening, mixing, kneading, wet process, etc.

2. The introduction of the China Coal Type Extruder

Combustion performance index requirements: Due to the fine coal rods products, to achieve and exceed the related regulations of calorific value, civilian the calorific value of coal general rules is from 18 to 20 MJ/kg. Because the quality of the raw coal is different, different calorific value, so the type coal technology with blending. General blending is on the first working procedure in production process.

3. Operating Instructions of the China Coal Type Extruder

Operators should be read operating instructions carefully before operate Coal Type Extruder.
Tens of minutes before starting, firstly, inspect lubrication degree of equipment, the loose screws and bolts and elastic situation of v-belt, then commissioning.

Secondly, the drive starts two consecutive start is not successful, you should stop. You should not drive until finding out the reasons and troubleshooting.

Thirdly, operators should moderately adjust the feed rate of and how much material water content according to the index of ammeter. The water content is about 12% - 14% of material to ensure the strength of coal rods molding (including 220KW motor current should be controlled between 350-400A; 90 KW motor current should be controlled between 150-165A; 110KW motor current should be controlled between 175-200A), moderately control the coal, avoid cutting or excessive feeding.

Fourth, in order to prevent material spray from injuring staff, do remember that machine head are strictly forbidden standing person in the first 10m.

Fifth, ban with iron materials of high hardness tool stirring Coal Type Extruder, so as not to be mixed into Coal Type Extruder and damage the machine. When the stirring stick goes in, you should immediately let it go to avoid being hurt, then stop and clean the machine.

Sixth, once the nose hole is blocked, you should make it unblocked in time.

Seventh, if the Coal Type Extruder downtime is for more than 2 hours, you should clean the interior materials, and add a small amount of water while driving again.

Finally, before installing the nose, you should keep the nose and discharge shell clean without coal on both ends of the shell assembly place, and then load clamping device.

4. Package of the China Coal Type Extruder,

Nude package of the body machine,
Box for the spare parts.