bimetal wearing plate

 bimetal wearing plate I . Product mold introduction * HP100   (Low stress abrasive wear) HP100 hard-faced wear-resistant steel plate is suitable for the low stress, little impact abrasive wear or fine particles, minimal energy and small incident Angle erosion wear condition. Hard-facing layer main chemical composition of metal (Wt%)

C	Cr	B	Other
3~5	20~28	+	4~8

       Hard-facing layer hardness: 60-65HRC  Wear resistant temperature: <500℃   * HP200   (Resistance to medium impact abrasive wear) HP200 hard-faced wear-resistant steel plate is suitable for the medium impact abrasive wear or rolling compaction wear condition under high pressure.   Hard-facing layer main chemical composition of metal (Wt%)

C	Cr	Mo	Mn	Other
2~5	20~26	+	1~3	2~5

          Hard-facing layer hardness: >58HRC  Wear resistant temperature: <500℃    *HP300   (Resistance to high temperature abrasive wear) HP300 hard-faced wear-resistant steel plate is suitable for high temperature abrasive wear and fine particles, small Angle, small energy impact wear conditions   Hard-facing layer main chemical composition of metal (Wt%)

C	Cr	Nb	Mn	Other
4~6	18~24	5~8	2~3	3~6

         Hard-facing layer hardness: 60-68HRC Wear resistant temperature: <800℃ II   Dimension

Model	Spec(mm)	Total Thickness	Size	Minimum curling radius
HP100/ HP200/ HP300	Base material + wearing layer	(mm)	(W+L)mm	(mm)
	5+3	8±0.5	1450×2000	R≥300
	6+4	10±0.5	1450×2000	R≥300
	6+6	12±0.5	1450×2000	R≥300
	8+6	14±0.5	1450×2000	R≥360
	10+6	16±0.5	1450×2000	R≥400
	12+6	18±0.5	1450×2000	R≥400
	8+7	15±0.5	1450×2000	R≥360
	10+7	17±0.5	1450×2000	R≥360
	10+8	18±0.5	1450×2000	R≥360
	12+8	20±0.5	1450×2000	R≥400
Remark: 1. This minimum curling radius is subject to a wear-resisting layer turning inward , if wear-resisting layer turning outwards, the minimum curling radius shall be multiply by 2. 2. We can also supply the special specification and size according to customer requirement.

  III. Technical Specification l  Havel hard-faced wear-resistant steel plate is adopted special technique that enable the hardness between the layers uniform(0.5mm), so as to effectively guarantee the whole wear layer has the same abrasive resistance. l  Wear layer thickness tolerance: +0.5/-0.5mm. l  The Mounting face warp degree of liner plate for Havel hard-faced wear-resistant steel plate :≤3mm/1000mm l  Crack of Wear layer: evenly spaced, tiny crack, not widely expand. l  Surface layer size: smooth, no obvious roughness. l  Surface spray paint: uniform paint layer, no need putty to repair, keep the state of nature. l  Cutting edge of wearing plate: four sides, linearity, no raw edges, good forming by using large plasma cutting machine. IV. Product pictures V. Application pictures