adsorption air dryer working principle

Working principle of micro heat regeneration
The dehumidification principle of micro heat regenerative adsorption dryer is basically the same as that of non heat, except that it is used for low-pressure drying of regeneration
The air is heated first and then enters the regeneration tower to dehumidify the desiccant. A heating device is added to the structure. In the regeneration procedure
Add hot and cold blowing processes.
The advantage of micro heat regeneration adsorption dryer is less energy waste, only 6%. Moreover, the switching cycle is long and the wear of parts is reduced,
The reliability of the equipment is improved.
The non thermal adsorption dryer consumes a lot of gas, and the micro thermal adsorption dryer has a heater, so it consumes a lot of power.

The adsorption dryer uses advanced chemical technology. The principle is to use the saturated compressed air to use the difference between the water and the air molecule volume. The special molecular sieve for gas purification is used to filter out the saturated water vapor in the compressed air, which can easily remove the water molecules. Adsorbed in molecular sieve particles, and then using regeneration method to reduce molecular sieve, the compressed air dew point can easily reach -40 ℃.

When installing  Air Dryer, we will also be equipped with three-stage filter Precision Air Filter is to remove pollutants in compressed air, such as dust, oil, iron filings, dirt, solid particles and other sundries, and provide high-quality compressed air that meets the supply demand for the air compressor system. Sectional installation is to effectively improve air quality and increase the service life of dryer and air Storage tanks. Only in this way can we improve higher efficiency and value.